Knowledge Base » SP01659

Important information about the ATC35L/ATC45L of the first months of production Suppose you intend to replace the bearings, piston, or levers in the ATC35L or ATC45L transfer cases made in the first months of production. In that case, you should keep the following fact in mind: a few months after the start of production of these transfer cases, the manufacturer changed the design—it switched from using thrust needle cages (No. 24 in the diagram) to needle bearing assemblies with washers.This also entailed changing the thickness of parts 22 (piston), 25 (moving lever), and 27 (fixed lever). That is, the indicated...